Контроль скорости

• Заказные данные
  (2)
• Информационные материалы

  Информационные материалы

  Реле контроля скорости 3UG48 51 применяются совместно с датчиком, для контроля превышения и понижения.

  Кроме того, они отлично подходят для контроля процессов с постоянными пульсирующими сигналами ( как то: контроль лент, целостности, прохождения , периодических процессов)

  Область применения

  • Проскальзывание или обрыв ремня 
  • Контроль перегрузки 
  • Контроль целостности лент и транспортеров

  Особенности

  • Настраивается на превышение, понижение и нахождение в пределах
  • Конфигурируемые времена срабатвания и сброс
  • Отображение значений и передача значений и сообщения об ошибке на контроллер
  • Для особо медленных моторов применяется до 10 датчиков на оборот
  • Могут подключаться 2- и 3-проводные датчики с сухими контактами и полупроводниковыми выходами 
  • Встроенное питание для датчика
  • Все версии со съемными клеммниками
  • Все версии возможны с обоими типами клеммника - пружинными и винтовыми
    

  Технические данные

  3UG4851 monitoring relays

  The speed monitoring relay operates according to the principle of period duration measurement.

  In the monitoring relay, the time between two successive rising edges of the pulse encoder is measured and compared to the minimum and/or maximum permissible period duration calculated from the set limit values for the speed.

  Thus, the period duration measurement recognizes any deviation in speed after just two pulses, even at very low speeds or in the case of extended pulse gaps.

  By using up to ten pulse encoders evenly distributed around the circumference, it is possible to shorten the period duration, and in turn the response time. By taking into account the number of sensors in the monitoring relay, the speed continues to be indicated in rpm.

  ON-delay time for motor start

  To be able to start a motor drive, and depending on whether the open-circuit or closed-circuit principle is selected, the output relay switches to the GO state during the ON-delay time, even if the speed is still below the set value.

  The ON-delay time is started by either switching on the auxiliary voltage or, if the auxiliary voltage is already applied, by actuating the respective NC contact (e.g. auxiliary contact).

  Speed monitoring with Auto RESET (Memory = no)

  If the device is set to Auto RESET, the output relay switches to the GO state, once the adjustable hysteresis threshold is reached in the range of 1 ... 99.9 rpm and the flashing stops. Any overshoots or undershoots are therefore not stored.

  Speed monitoring with Manual RESET (Memory = yes)

  If Manual RESET is selected in the menu, the output relay remains in its current switching state and the current measured value and the symbol for overshooting/undershooting continue to flash, even when the speed returns to a permissible value. This stored fault status can be reset by pressing the UP▲ and DOWN▼ keys simultaneously for > 2.5 s or by connecting the RESET device terminal to 24 V DC.

  With Manual RESET through IO-Link it is possible in addition to set whether error signals are to be deleted when the control supply voltage is switched off and on (as remote RESET) or whether the signals are to be permanently saved even in a voltage failure, with confirmation possible only through local RESET, the remote RESET contact or via IO-Link.

  With the closed-circuit principle selected

  Range monitoring without enable input

  

  Range monitoring with enable input