- Каталог оборудования Siemens
- Каталог продуктов Siemens Industry
- Приводная техника
- Преобразователи
- Стандартные преобразователи
- Общая информация о базовых преобразователях SINAMICS V
- Преобразователи частоты общего назначения SINAMICS G
- Высокопроизводительные преобразователи SINAMICS S
- Сервопреобразователь SINAMICS S110
- SINAMICS S120
- SINAMICS S120M distributed servo drive
- SINAMICS S120 Combi
- SINAMICS S120 Chassis Format Units
- Air-cooled units
- Liquid-cooled units
- System components
- Line-side power components
- DC link components
- Motor-side power components
- Control Units
- Supplementary system components
- BOP20 Basic Operator Panel
- AOP30 Advanced Operator Panel
- CBC10 Communication Board
- CBE20 Communication Board
- DMC20 DRIVE-CLiQ Hub Module
- DME20 DRIVE-CLiQ Hub Module
- TB30 Terminal Board
- TM15 Terminal Module
- TM31 Terminal Module
- TM41 Terminal Module
- TM54F Terminal Module
- TM120 Terminal Module
- TM150 Terminal Module
- VSM10 Voltage Sensing Module
- Safe Brake Adapter SBA
- Encoder system connectionSMC10 Sensor Module Cabinet-MountedSMC20 Sensor Module Cabinet-MountedSMC30 Sensor Module Cabinet-Mounted
- Encoder system connection
- Connection system
- SINAMICS S120 Cabinet Modules
- SINAMICS S150 converter cabinet units
- MICROMASTER
- SIPLUS POSMO A
- SIMODRIVE POSMO
- LOHER DYNAVERT Drive System
- Преобразователи на среднее напряжение
- Преобразователи постоянного тока
- Стандартные преобразователи
- Двигатели переменного тока
- Generators
- Мотор-редукторы
- Flender Gear Units
- Couplings
- Инструментальное программное обеспечение
- Дополнительные компоненты
- Преобразователи
- Техника автоматизации
- Energy
- Автоматизация и безопасность зданий
- Низковольтная коммутационная техника
- Технология безопасности
- Системные решения и продукты для отраслей
- Сервис
- Приводная техника
Encoder system connection
- Информационные материалы
Информационные материалы
Motors without DRIVE-CLiQ interface
The encoder and temperature signals of motors without DRIVE‑CLiQ interfaces, as well as those of external encoders, must be connected via Sensor Modules. Sensor Modules Cabinet-Mounted are available in degree of protection IP20 for control cabinet installation, as well as Sensor Modules External-Mounted in degree of protection IP67.
Only one encoder system can be connected to each Sensor Module.
Дальнейшая информация
Motor encoder and temperature signals must be connected to the corresponding Motor Module or Power Module and external encoders to the Control Unit. However, the DRIVE‑CLiQ connections can also be bundled via DRIVE‑CLiQ Hub Modules.
Safety Integrated
Suitable encoders are required in order to allow unrestricted use of Safety Integrated Extended Functions.
Belt-driven motor
Unfavorable material combinations generate static electricity between the belt pulley and the belt. Electrostatic charging must be prevented, since this can discharge via the motor shaft and the encoder, thereby causing disturbances in the encoder signals. One remedy is to use an anti-static belt.