System power supplies

Заказные данные
(3)
Аксессуары
(8)

Power supplies for the SIMATIC S7-1500
For conversion of AC or DC line voltages to the operating voltages required for the internal electronics
25 or 60 W output power
Can be used for S7-1500 or ET 200MP
Configuration via STEP 7 V12 and higher

Область применения

Power supplies (PS) supply the internal electronics of the S7-1500 modules with power via the backplane bus. They are required, for example, if the power supplied by the CPU or the interface modules to the backplane bus is not sufficient to supply all connected modules or if more than one power segment in the S7-1500 configuration or in distributed configuration in the ET 200MP should be implemented.

Дизайн

Power supplies are screwed directly to the S7-1500 mounting rail and are connected with the upstream or downstream module via a U connector.

The front of the power supply contains:

Diagnostics LEDs to indicate status and errors:
Error (Error), operation (RUN), maintenance (MAINT)

The power supplies also include:

On/off switch
Power supply terminals

Функции

Properties:

Rated input voltage dependent on the type of module
Output power dependent on the type of module
Mains buffering
Galvanic isolation from the bus

The following functions are supported by the power supply modules:

Firmware update
Identification and maintenance data I&M0 to I&M3
Configuring in RUN
Diagnostic messages
Diagnostics interrupts

Технические данные

Order number	6ES7505-0KA00-0AB0	6ES7505-0RA00-0AB0	6ES7507-0RA00-0AB0
	S7-1500, PS 25W 24V DC	S7-1500, PS 60W 24/48/60V DC	S7-1500, PS 60W 120/230V AC/DC
General information
Product type designation	PS 25W 24VDC	PS 60W 24/48/60V DC	PS 60W 120/230V AC/DC
Engineering with
● STEP 7 TIA Portal configurable/integrated as of version	V12 / V12	V12 / V12	V12 / V12
● STEP 7 configurable/integrated as of version	V5.5 SP3 or higher	V5.5 SP3 or higher	V5.5 SP3 or higher
Supply voltage
Rated value (DC)	24 V	24 V / 48 V / 60 V	120 V / 230 V
permissible range, lower limit (DC)	Static 19.2 V, dynamic 18.5 V	Static 19.2 V, dynamic 18.5 V	88 V
permissible range, upper limit (DC)	Static 28.8 V, dynamic 30.2 V	Static 72 V, dynamic 75.5 V	300 V
Rated value (AC)			120 V / 230 V
permissible range, lower limit (AC)			85 V
permissible range, upper limit (AC)			264 V
Reverse polarity protection	Yes	Yes
Short-circuit protection	Yes	Yes	Yes
Line frequency
● Rated value 50 Hz			Yes
● permissible range, lower limit			47 Hz
● permissible range, upper limit			63 Hz
Mains buffering
● Mains/voltage failure stored energy time	20 ms	20 ms	20 ms
Input current
Rated value at 24 V DC	1.3 A	3 A
Rated value at 48 V DC		1.5 A
Rated value at 60 V DC		1.2 A
Rated value at 120 V DC			0.6 A
Rated value at 230 V DC			0.3 A
Rated value at 120 V AC			0.6 A
Rated value at 230 V AC			0.34 A
Output current
Short-circuit protection	Yes	Yes	Yes
Power
Infeed power to the backplane bus	25 W	60 W	60 W
Power loss
Power loss at nominal rating conditions	6.2 W	12 W	12 W
Interrupts/diagnostics/status information
Status indicator	Yes	Yes	Yes
Potential separation
primary/secondary	Yes	Yes; Electrical isolation for 230 V AC (reinforced isolation)	Yes
Isolation
Isolation tested with	707 V DC (type test)	2 500 V DC/2 s (routine test)	2 500 V DC/2 s (routine test)
EMC
Interference immunity against voltage surge
● on the supply lines acc. to IEC 61000-4-5	Yes; +/- 1 kV (acc. to IEC 61000-4-5; 1995; surge symm.), +/- 2 kV (acc. to IEC 61000-4-5; 1995; surge asymm.), no external protective circuit required	Yes; +/- 1 kV (acc. to IEC 61000-4-5; 1995; surge symm.), +/- 2 kV (acc. to IEC 61000-4-5; 1995; surge asymm.), no external protective circuit required	Yes; +/- 1 kV (acc. to IEC 61000-4-5; 1995; surge symm.), +/- 2 kV (acc. to IEC 61000-4-5; 1995; surge asymm.), no external protective circuit required
Degree and class of protection
Degree of protection acc. to EN 60529	IP20	IP20	IP20
Protection class	3; with protective conductor	1; with protective conductor	1; with protective conductor
Dimensions
Width	35 mm	70 mm	70 mm
Height	147 mm	147 mm	147 mm
Depth	129 mm	129 mm	129 mm
Weights
Weight, approx.	350 g	600 g	600 g

Дальнейшая информация

Further information and downloads

Manuals

The SIMATIC S7-1500 manuals can be downloaded free of charge from the Internet (SIMATIC Customer Support).

http://support.automation.siemens.com/WW/view/en/86140384

SIMATIC S7-1500 Display Simulator

Using the Display Simulator of the S7-1500, you can become familiar in advance with the different setting options and functions on the display.

http://www.automation.siemens.com/salesmaterial-as/interactive-manuals/getting-started_simatic-s7-1500/disp_tool/start_en.html

General information

http://www.siemens.com/S7-1500

SIMATIC Selection Tool

http://www.siemens.com/tia-selection-tool

Brochures

Information material for downloading can be found on the Internet:

http://www.siemens.com/simatic/printmaterial